Sherwood Newcastle R-865 Operating Instructions Manual page 38

Adjust the level of the selected channel as
2
desired.
or
DOWN
UP
Adjusting the Dolby Pro Logic IIx / Dolby Pro Logic II Music parameters
• When selecting either the Dolby Pro Logic IIx Music mode or the Dolby Pro Logic II Music mode depending on
whether "S/B CH" is set to "None" or not, you can adjust the various surround parameters for optimum surround
effect.(Refer to "When selecting the SPEAKER CONFIGURATION" on page 49.)
• In case of PL IIx MUSIC mode, only when original surround mode is "BYPASS" mode or 2 channel digital signals
from Dolby Digital sources, etc. are input, these parameter settings affect the surround effects.
Press the DOLBY PL II MUSIC PARAMETER button to select the desired parameter.
1
or
At the desired parameter, adjust it as desired.
2
or
DOWN
UP
• If the parameter display disappears, start from the
step again.
Repeat the above steps
3
each channel level.
• Each time this button is pressed, the parameter changes
and is displayed for several seconds as follows;
Panorama mode("PANORAMA", default value : OFF)
This mode extends the front stereo image to include
the surround speakers for an exciting "wraparound"
effect with side wall imaging. Select "OFF" or "ON".
Center width control("C-WIDTH", default value : 0)
This adjusts the center image so it may be heard only
from the center speaker, only from the left/right
speakers as a phantom image, or from all three front
speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
Dimension control("DIMENSION", default value : 0)
This gradually adjusts the soundfield either towards
the front or towards the rear. The control can be set
in 7 steps from -3 to +3.
Repeat the above steps
3
adjust other parameters.
38
and to adjust
and to