Sherwood Newcastle R-865 Operating Instructions Manual page 24

Programing a punch-through function
• The punch-through function allows the volume
controls , channel controls or transport controls to
link to a different device while a device is controlled
with this remote control as a master device.
• For example, since this receiver will likely be used
as the sound system while watching TV, you may
want to use volume controls to operate this receiver
although this remote control is set to control the TV.
Perform the steps
1
setup code" procedure on page 19 to select
a master device and the punch -through
mode ("PUNCH").
• Then "VOL" is displayed on the LCD screen for
several seconds.
While the device is displayed, press the
3
CURSOR UP( )/DOWN( ) buttons to
select the desired punch-through device,
then press the ENTER button.
• Each time the CURSOR UP( )/DOWN( ) buttons
are pressed , depending on the selected punch-
through mode, punch-through devices and the one
punch-through deleting mode ("DELETE") are
selected as follows :
• In case of the volume punch-through,
AUDIO DELETE TV
• In case of the transport punch-through,
CD DELETE DVD
• In case of the channel punch-through,
TV DELETE SAT
• Then "OK" is displayed and the current punch-
through mode is displayed.
and in "Entering a
VCR AUX
CABLE VCR
24
While "VOL" is displayed, press the
2
CURSOR UP( )/DOWN( ) buttons to
select the desired punch-through mode ,
then press the ENTER button.
• Each time the CURSOR UP( )/DOWN( )
buttons are pressed, the mode changes as follows:
VOL : The volume punch -through mode allows
the "VOLUME / " and "MUTE" buttons to
function to operate a different device.
DELETE : All punch-through deleting
mode.
PLAY : The transport punch-through mode allows
the " ", " ", "
" and " " buttons to function to operate a
different device.
CH : The channel punch-through mode allows the
"CH/ADJUST / " and "CH. SEL" buttons
to function to operate a different device.
• Then the device to which you can link the selected
punch-through mode is displayed.
While the punch-through mode is
4
displayed, repeat the above steps
to program other punch-through function
under the same master device mode.
To program punch-through functions under
5
other master device mode, repeat the above
steps to .
", " ", " ", " ", "
and