Sherwood Newcastle R-865 Operating Instructions Manual page 37

Adjusting each channel level with test tone
• The volume level of each channel can be adjusted easily with the test tone function.
Note: When speakers are switched off , the test tone function does not work.
Enter the test tone mode.
1
At each channel, adjust the level as desired
2
until the sound level of each speaker is
heard to be equally loud.
or
DOWN
UP
• You can select the desired channel and adjust its
level with repeating the steps
"Adjusting the current channel levels" procedure.
Adjusting the current channel levels
• After adjusting each channel level with test tone, adjust the channel levels either according to the program
sources or to suit your tastes.
• If you have performed the CH LEVEL SETUP procedure on the OSD menu, you can memorize the adjusted
channel levels into preset memory(PRESET 1, PRESET 2) and recall the memorized whenever you want.
(Refer to "SETTING THE CH LEVEL SETUP" on page 66.)
Select the desired channel.
1
or
• The test tone will be heard from the speaker of each
• Depending on the speaker setting(None or No), the
• ( ): possible depending on whether the surround back
and in
• Each time this button is pressed, the corresponding
• ( ): possible depending on whether the surround back
37
channel for 2 seconds as follows:
FL FC FR
Front Left Center Front Right
SUB SL ( SC) or (
SUBwoofer Surround Left (Surround Center)
test tone of the corresponding channel is not
available.
channel is set to 2 CH or 1 CH.
Cancel the test tone function.
3
channel is selected as follows:
FRONT-L FRONT-C FRONT-R
SUBWOOFER SURR-L ( SURR-C) or ( BACK-L BACK-R)
• Depending on the speaker settings and surround
mode, etc., some channels cannot be selected.
channel is set to 2 CH or 1 CH.
Note: When speakers are switched off, only
FRONT-L and FRONT-R channels can be
selected.
SR
Surround Right
B L BR)
(Surr. Back Left Surr. Back Right)
SURR-R