Basic Playback - Sherwood Newcastle V-756 Operating Instructions Manual

Operations

BASIC PLAYBACK

■Preparations
Turn on the TV and select the video input source connected to the unit.
To enjoy the sound of the disc from your audio system, turn on the audio system and select the input source
connected to the unit.
Set the TV screen type correctly to match your TV.
Before operation, enter the standby
1
mode.
Main unit
In the standby mode, turn the power on.
2
RC
Open the disc tray, then load a disc with
3
the printed side up.
Main unit
or
Start playback.
4
Main unit
or
Note :
When you play a DVD Video, the menu display
may appear on the TV screen. In this case, see
"To start playback from the menu" on the next
page.
RC
RC
15
The STANDBY indicator lights up. This means that
the unit is connected to the AC mains and a small
amount of current is retained to support operational
readiness.
To switch the power off, push the POWER switch
again. Power is cut off and the STANDBY indicator
goes off.
Each time the POWER button on the remote
control is pressed, the unit is turned on to enter the
operating mode or off to enter the standby mode.
In the stanby mode, if the OPEN/CLOSE button is
pressed, the unit can be also turned on (and when
there is a disc in the unit, the disc is automatically
played back).
8 cm (3 inch) discs can be loaded on the inside
circle of the tray, too.
The disc tray closes and playback starts.
When the disc tray is closed by pressing the
OPEN/CLOSE button, playback starts, too.
Example of DVD Video
TITLE MENU
Dogs
Cows Horses
Cats