Advertisement
Setting Up
1
.
Connect all cords.
2.
Attach the Base Stand.
3.
Attach the Headset Holder.
4.
Attach the Battery
to the Remote.
2
1
5.
Connect the Headset
to the Remote.
6.
Slide the Remote into the Charger
on either side of the Base. The
Battery Charge light on the side of
the Base illuminates. Charge the
Battery for a full 3 hours. Use the
Handset while the Battery charges.
7.
Put the System in Headset Mode.
The Headset Mode light on the
top of the Remote blinks, and the
Headset Mode light on the side of
the Base illuminates.
It will take up to 45 seconds to establish a
channel with first use.
8.
Make sure the Mute is off.
When Mute is on, a tone sounds in the
Headset every 3 seconds.
9.
Put the Headset on and select a
telephone compatibility setting
until dial tone is clear. If dial
tone is clear for both A and G,
set to A.
10.
Remove the Handset and
make a call. While switching
between the Headset and
Handset, adjust the transmit
(microphone) setting until
your voice is the same volume
on both devices (1 is the softest,
8 is the loudest). Most settings
are 5-7. If the best setting is 7
or 8, change the telephone
compatibility setting to G.
Disconnect the optional Remote Handset
Lifter from the Base while setting the
volume.
11.
Use the Remote Beltpack to adjust
the receive (speaker) volume. If
your telephone has volume control,
set it to mid-range.
Advertisement
