Advertisement
Remote Beltpack Functions
1
Headset Mode Indicator:
1
Blinks when the system is in headset mode;
no light in handset mode.
2
2
Volume Control:
Press + to increase volume.
Press - to decrease volume.
3
3
Mute Button:
4
Press to activate Mute and disable the
transmit/microphone; press again to enable
transmit/microphone.
4
Headset/Handset
& Remote Handset Lifter Buttons:
Press to enter headset or handset mode as
desired (lights on remote and base light in head-
set mode); press again to answer a call with the
Remote Handset Lifter (optional).
5
Base Functions/Indicators
5
Transmit Settings:
Adjusts the volume of your voice.
6
6
Telephone Compatibility Settings:
Fine tunes the system to your telephone system.
7
Battery Charge Indicator:
Lights when the remote is properly seated
in the base charger.
8
Headset Mode Indicator:
Lights when the system is in headset mode;
no light in handset mode.
7
8
Audio Indicators
Mute
Tone sounds in headset every 3 seconds.
Out of Range
Tone sounds in headset every 10 seconds.
Low Battery
Tone sounds in headset every 20 seconds.
Volume
Tone sounds in headset at maximum and minimum range.
Battery Information
Nickel Metal Hydride (NiMH), 3.6 V 500 mAH
Battery Type
(GN Netcom part number 27381101).
Fully charged battery provides minimum of 12 hours
continuous use without recharging.The base has two
Capacity On-Line
charging ports; additional battery can be purchased for
24/7 operation.
Fully charged battery provides minimum 80 hours
Capacity Off-Line
without recharging.
Maximum 3 hours to completely recharge a discharged
Recharging Time
battery; battery cannot be overcharged.
2 years if battery is recharged when not in use
Battery Life
and never completely discharged.
Recharging the Battery
Slide the Remote into the Charger on either side of the base. To use your Headset while charging,
put the System in Headset Mode. To charge overnight, put the System in the Handset Mode.
Discharging the Battery
For optimum Battery life, completely discharge the Battery approximately every 6 months. The
Discharge/Recharge cycle takes approximately 2 hours. Removing the Remote from the Base during
discharge cancels the operation. Only one Battery can be placed in the Base while discharging.
A. Slide the Remote into the Charger on either side of the Base.
B. Simultaneously press the Mute and Headset/Handset buttons for 5 seconds. The Headset Mode and
Battery Charger Indicators will flash alternately during discharge. When fully discharged, the Battery
automatically recharges.
Advertisement
