Table of Contents
Advertisement
IMPORTANT SAFEGUARDS
LAMP REPLACEMENT
CAUTION
BEFORE REMOVING THE SCREW, DISCONNECT
POWER CORD. HOT SURFACE INSIDE
ALLOW 1 HOUR TO COOL BEFORE REPLACING
THE LAMP. REPLACE WITH SAME SHARP LAMP
UNIT TYPE BQC-XGP20X//1 ONLY.
UV RADIATION : CAN CAUSE EYE DAMAGE.
TURN OFF LAMP BEFORE SERVICING.
MEDIUM PRESSURE LAMP : RISK OF EXPLOSION.
POTENTIAL HAZARD OF GLASS PARTICLES IF
LAMP HAS RUPTURED. HANDLE WITH CARE.
SEE OPERATION MANUAL.
CAUTION
PRECAUCIÓN
PRÉCAUTION
E-3
Caution Concerning the Lamp
Replacement
See "Replacing the Lamp" on pages
PRODUCT DISPOSAL
This product utilizes tin-lead solder, and high intensity
discharge lamp (HID lamp) containing a small amount of
mercury. Disposal of these materials may be regulated due
to environmental considerations. For disposal or recycling
information, please contact your local authorities or the
Electronics Industries Alliance: www.eiae.org.
Caution Concerning the Lamp Unit
Potential hazard of glass particles if lamp ruptures. In
case of lamp rupture, contact your nearest Authorized
Sharp Industrial LCD Products Dealer or Service Center
for a replacement.
See "Replacing the Lamp" on pages
Cautions Concerning the Setup of
the Projector
For minimal servicing and to maintain high image quality,
SHARP recommends that this projector be installed in
an area free from humidity, dust and cigarette smoke.
When the projector is subjected to these environments,
the lens must be cleaned more often. As long as the
projector is properly maintained in this manner, use in
these environments will not reduce the overall operation
life. Please note that all internal cleaning must be
performed by an Authorized Sharp Industrial LCD
Products Dealer or Service Center.
Notes on Operation
• The exhaust vent, the lamp cage cover and adjacent
areas may be extremely hot during projector
operation. To prevent injury, do not touch these areas
until they have sufficiently cooled.
• Allow at least 4 inches (10 cm) of space between the
exhaust vent and the nearest wall or obstruction.
• If the cooling fan becomes obstructed, a protection
device will automatically turn off the projector lamp.
This does not indicate a malfunction. Remove the
projector power cord from the wall outlet and wait at
least 10 minutes. Then turn on the power by plugging
the power cord back in. This will return the projector
to the normal operating condition.
and
.
68
69
and
.
68
69
Advertisement
Table of Contents
