Dehumidifying (Dry) Operation; Adjusting Air Flow Direction; Timer Operation - Rinnai HINRA35M Operation Manual

Dehumidifying (DRY) Operation

Ensure the unit is plugged in and power is
available. The OPERATION indicator on the
display panel of the indoor unit starts flashing.
1. Press the MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the
desired temperature. The temperature
can be set within a range of 17 C~ 30 C
O
in 1 C increments.
3. Press the ON/OFF button to start the air
3
conditioner.
2 ON/OFF 2
NOTE
TEMP
In Dehumidifying mode, you can not control the
1
fan speed. It is automatically controlled by the unit.
SHORT
MODE
CUT
FAN
SPEED
SWING

Adjusting Air Flow Direction

Use the SWING
TIMER
SWING ON
the desired airflow direction.
1. Press the SWING
TIMER
SLEEP
OFF
louver changes 6 degree in angle for each push.
Press and hold for more than 2 seconds, and
TURBO LED
SELF
FOLLOW
CLEAN
ME
the louver will automatically swing up and down.
2. Press the SWING
RESET
LOCK
louver changes 6 degree in angle for each push.
Press and hold for more than 2 seconds, and
the louver will automatically swing left and right.
NOTE: When the horizontal/vertical louver swing
O O
and SWING buttons to adjust
button, and the horizontal
button, and the vertical
moves to a position which may affect
the cooling or heating effect of the air
conditioner, it may automatically change
the horizontal or vertical position.
9

Timer operation

Press the TIMER ON button to set the auto-on
time of the unit. Press the TIMER OFF button
to set the auto-off time of the unit.
To set the Auto-on time.
1. Press the TIMER ON button. The remote
control shows TIMER ON, the last Auto-on
setting time and the signal "H" will be shown in
the LCD display area. Now it is ready to reset
ON/OFF
the Auto-on time to the START time.
TEMP
2. Press the TIMER ON button again to set desired
Auto-on time. Each time you press the button,
SHORT
MODE
CUT
the time increases by half an hour between 0
and 10 hours and by one hour between 10 and
FAN
SPEED
SWING
24 hours.
3. After setting the TIMER ON function, there will be a
TIMER
1
SWING ON
one second delay before the remote control
transmits the signal to the air conditioner. Then,
TIMER
2
SLEEP
OFF
after approximately another 2 seconds, the
signal "H" will disappear and the set temperature
TURBO
LED
SELF FOLLOW
CLEAN ME
will re-appear in the LCD display window.
LOCK RESET
To set the Auto-off time.
1. Press the TIMER OFF button. The remote
control shows TIMER OFF, the last Auto-off
setting time and the signal "H" will be shown in
the LCD display area. Now it is ready to reset
the Auto-off time to stop time.
2. Press the TIMER OFF button again to set
desired Auto-off time. Each time you press the
button, the time increases by half an hour
between 0 and 10 hours and by one hour
between 10 and 24 hours.
3. After setting the TIMER OFF function, there will be
a one second delay before the remote control
transmits the signal to the air conditioner. Then,
after approximately another 2 seconds, the
signal "H" will disappear and the set temperature
will re-appear in the LCD display window.
10