Anti-Theft (Setting The Anti-Theft) - Sharp Notevision PG-B10S Operation Manual

Using the "Options" Menu
Anti-Theft
The anti-theft function prevents unauthorized use of
the projector. You can choose to use this function or
not. If you do not want to use this function, just do
not enter the keycode. Once the anti-theft function is
activated, users will need to enter the correct keycode
each time the projector is turned on. Failure to enter
the correct keycode will cause images to not be pro-
jected. The following procedures explain how to use
this function.
Setting the menu screen
Example: "Options" menu screen for
INPUT 2 (S-Video) mode
If you want to set the keycode, follow the
procedure below.
1
Select "Anti-Theft" on the "Op-
tions" menu, then press
The password input box will appear.
2
' ' ' ' , " " " and | | | | | to enter the " "
Press '
password.
The keycode input box will appear.
" On-screen display (keycode)
-46
(Setting the Anti-Theft)
Page 34
.
3
Press any button you like on the re-
mote control or projector to set the
first digit in "New Code".
Note
The following buttons on the remote control and
projector cannot be set as keycodes:
ON button
STANDBY button
ENTER button
UNDO button
MENU button
FORWARD button
BACK button
4
Enter the remaining 3 digits by
pressing any buttons you like.
5
Enter the same keycode once more
in "Reconfirm".
Note
When "Anti-Theft" is set, the keycode in-
putting box appears after the power is
turned on. When it appears, enter the right
keycode.
Press the buttons on the remote control if the
buttons on the remote control are used for set-
ting the keycode. In the same manner, press
the buttons on the projector if the buttons on
the projector are used for setting the keycode.
"Anti-Theft" cannot be selected unless
"Password" is set. (See page 45.)
When "Anti-Theft" is selected, the password in-
put box will appear. Enter the keycode after the
right password is entered.
Info
Once the function is activated, you must remem-
ber the correct keycode. We suggest you record
the keycode in a safe place where only autho-
rized users have access. If you lose or forget
your keycode, you will need to contact your
nearest Sharp Authorized Projector Dealer or
Service Center (see page 73). You may need
to bring your projector to them to restore the
projector to original factory condition (password
and keycode reset).