Quiet Detect Start Time - Sharp UX-B30 Owner's Manual

all.book Page 75 Tuesday, June 1, 2004 4:24 PM

Quiet Detect Start Time

This setting can be used to delay the start of the Quiet Detect Time function.
For example, if you want to insert a pause at the beginning of your answering
machine's outgoing message to ensure clear detection of fax signals, you can
use this setting to delay the start of silence detection so that the pause will not
cause the fax to take over the line.
Quiet Detect Start Timing has been turned off (set to "00" seconds) at the
factory. If you want to use this function, turn it on by entering a 2-digit number
equal to the desired number of seconds of the delay. As general guide, the
delay time should be slightly longer than the pause before the outgoing
message.
1
Press once and
2
Press once and
3
Press once.
4
Enter a 2-digit number (from 01 to 15)
for the number of seconds of the delay,
or enter 00 to turn off the function.
Example: 3 seconds
STOP
5
Press to return to the date and time display.
Optional A.M. Mode Settings
Display:
3 times.
OPTION SETTING
QUIET START
6 times.
ENTER (00-15) 00
The display briefly shows
your selection, then:
ON A.M.FAILURE
75