Connecting The Power Cord - Sharp UX-B20 Operation Manual

Connecting the Power Cord

Connecting the Power Cord
Plug the power cord into a 120 V, 60 Hz, grounded AC (3-prong) outlet.
Caution!
♦
Do not plug the power cord into any other kind of outlet. This will damage
the machine and is not covered under the warranty.
♦
Make sure you have removed all of the packing tape before plugging
in the power cord (see page 10). Plugging in the power cord without
doing so may damage the machine.
The machine does not have
a power on/off switch, so
the power is turned on and
off by simply plugging in or
unplugging the power cord.
Note: If your area experiences a high incidence of lightning or power surges,
we recommend that you install surge protectors for the power and telephone
lines. Surge protectors can be purchased at most telephone specialty stores.
14
"CHECK CARTRIDGE" normally
appears in the display the first
time you plug in the machine.
This message appears until you
install the print cartridge.