Sharp UX-340L Operation Manual page 44

Setting Up and Using OpenLCR
Mark
(Blinking)
(Blinking)
Temporarily turning off OpenLCR
42
OpenLCR has been activated and is ready for use.
OpenLCR cannot be used because the rate data has
been erased. Your fax will automatically call
OpenLCR within the next 24 hours to receive new
data, or you can download the data manually if you
need to use OpenLCR immediately. See
Downloading (receiving) the rate data manually on
page 39.
The rate data in the fax is no longer correct and the
fax cannot connect to OpenLCR to obtain new data.
See What to do if "E" appears in the display on page
45.
OpenLCR has been temporarily turned off. See
Temporarily turning off OpenLCR below.
Rate data was not yet available when your fax called
OpenLCR. Your fax will automatically call OpenLCR
again when the rate data is available. Until that time,
long distance calls will be routed through your
primary carrier.
Your fax will automatically call OpenLCR within the next
24 hours to learn when correct rate data will be
available.
Meaning