Table of Contents
Advertisement
KPA Ku-Band Indoor Solid-State Power Amplifier
Preface
Electrical Safety and Compliance
This product contains a Lithium Battery.
battery is incorrectly replaced. Replace only with the same or equivalent type
recommended by the manufacturer. Dispose of used batteries in accordance with
WARNING
local and national regulations
This equipment has been designed to minimize exposure of personnel to hazards. The
operators and technicians must:
•
Know how to work around, with, and on high voltage and high RF power level
CAUTION
equipment.
•
Exercise every precaution to ensure personnel safety.
•
Exercise extreme care when working near high voltages/high RF power level
equipment.
•
Be familiar with the warnings presented in this manual.
•
Disconnect the power supply cord before servicing the ISSPA.
Electromagnetic Compatibility (EMC) Compliance
Properly shielded cables for DATA I/O are required in order to meet the European
Electromagnetic Compatibility (EMC) Directive (EN55022, EN50082-1). More specifically,
these cables must be shielded from end-to-end, ensuring a continuous ground shield.
IMPORTANT
In accordance with European Directive 2004/108/EEC, the KPA family of products has been
shown, by independent testing, to comply with the following standards:
Emissions:
Immunity:
European Low Voltage Directive (LVD)
The following information is applicable for the European Low Voltage Directive (2006/95/EC):
Symbol
Description
<HAR>
Type of power cord required for use in the European Community.
CAUTION: Double-pole/Neutral Fusing
!
ACHTUNG: Zweipolige bzw. Neutralleiter-Sicherung
EN 55022 Class B – Limits and Methods of Measurement of Radio
Interference Characteristics of Information Technology Equipment.
(Also tested to FCC Part 15 Class B.)
EN 55024 – Information Technology Equipment: Immunity Characteristics,
Limits, and Methods of Measurement.
xi
DANGER OF EXPLOSION EXISTS
Revision 1
MN/KPA.IOM
if the
Advertisement
Table of Contents
Troubleshooting
