Specifications - Sharp LL-T1610W Operation Manual

Product specifications
LCD display
40 cm measured diagonally
Anti Glare Low Reflection TFT LCD module
Resolution (max.)
SXGA 1280 X 1024
Displayable colors (max.)
Approximately 16.77 million colors (8 bit)
Brightness (max.)
230cd/m²
Dot pitch
0.248(H) 0.248(V) mm
Contrast ratio
300:1
Angle of visibility
Left-right 160°; Up-down 130°
Screen display size
Horizontal 317.8 mm X Vertical 254.2 mm
Video signal
Analog: Analog RGB (0.7Vp-p) [75 ]
Digital: DVI standard based on 1.0
Sync signal
Separate Sync (TTL level: +/-), Sync on Green,
Composite Sync (TTL level: +/-)
Expansion compensation
Digital screening (enlargement of display to correct
VGA/SVGA/XGA)
Plug & Play
VESA: DDC1/DDC2B compatible
Power management
VESA: based on DPMS
DVI: based on DMPM
Input signal terminal
Analog: 15 pin mini D-sub (3 rows)
Digital: 24 pin DVI-D
USB hub function
1 upstream port, 2 downstream ports (bus-powered
hub based on USB standard Rev 1.1)
Screen angle adjustment
Tilt: Upward: 0° - 30°
Swivel: Total from left through right: 90°
(turntable form)
Power supply
AC100-240V, 50/60Hz (Use special AC adapter, type
NL-A54J of Sharp Corporation.)
Temperature of operating environment
5 - 35°C
Power consumption
Maximum 32W (approximately 3W when in power-
saving mode)
(Use special AC adapter.)
Dimensions (excluding rubber base)
377 mm (W) X 180 mm (D) x 390 mm (H)
Weight
Approx. 5.4 kg (excluding AC adapter)

Specifications

Dimensions (Units: mm)
Length of analog signal cable: approx. 2.0 m*
Length of USB cable included: approx. 2.0 m
*Length from analog signal input terminal
Special AC adapter
Approx. H 125 mm x D 60 mm x H 33 mm
27
377
230
180
Approx. 2.0 m