Table of Contents
Advertisement
Counter leveling pads with a steamer counter seal (or optional feet) are in a bag within the canon Locate this bag before discarding the
shipping carton
NOTE: The use of leveling pads and steamer counter seat (gasket) on surfaces
other than stainless steel is not recommended
STEPS FOR ASSEMBLY
1) Carefully cut the shipping carton open for easy removal of the steam-
er. There are four clips mounted to the front two and rear two outer
sheeting mounting screws. These dips were used to lower the steamer
into the carton. They must be removed and discarded pnior to
installation. Reinstall the tour screws and tighten them securely, as
these screws also secure the outer sheet metal cover to the steamer.
2) Install the four leveling pads (or optional four legs) into the threaded
holes on the bottom of the steamer
3) (Omit this next step if optional 4' legs are supplied.) Install the
adjustable counter seal on the bottom edge of the body Begin by
pressing on one end of the sealing stnp at the middle of the bottom-
front edge. Continue applying the seal in a clockwise direction.
NOTE: The purpose of the counter seal is to provide
4) Remove the plastic dnp trough from the inside of the cooking compartment and install it by sliding it onto the mounting brackets
on the bottom-front of the steamer. Remove the fuse holder caps and fuses from the inside of the cooking compartment and
install them into the fuse holders on the back of the steamer.
The cooker should be placed in position and leveled left to right and front
to rear. The required clearances are:
Right
Side:
6"— 152mm
Left
Side:
12"—305mm
Installation of this unit must be done by qualified plumbing and electrical installation
personnel working to all applicable local and national codes Improper installation of
this product could cause inury or damage.
a sealing stnp between the cooker and the surface on which it is placed.
Some surfaces will require the use of additional sealant
Rear:
3'
'— 76mm
Vertical:
12
'—
'
305mm
Do not install any other equipment on
top of me Steamcraft II
ASSEMBLY
POSITIONING
Advertisement
Table of Contents
