Lenovo ThinkServer sd350 Installation And Service Manual page 97

Step 1. Turn off the server (see "Turning off the server" on page 29 for instructions) and all attached
peripheral devices. Disconnect all power cords; then, disconnect all external cables from the server.
Step 2. Install the four (two on each side) C-clips to the rack on the rear of the chassis. Make sure that the
thinner face is displayed outwards.
Figure 21. Installing the four C-clips
Step 3. Align the shipping brackets with the flanges and rails and install the four (two on each side) M6
screws to the brackets on the rear of the chassis.
M6 screws
Figure 22. Installing the shipping brackets
Step 4. Install the two (one on each side) 10–32 screws to the brackets on the rear of the chassis.
C-clips
Shipping bracket
.
Chapter 5 Removing and replacing server components
81