Recording From A Microphone - Sharp IM-DR420H Operation Manual

Recording from a Microphone

To the MIC IN
Stereo
( PLUG IN )
microphone
POWER
(commercially
socket
available)
1
Connect a stereo microphone to the MIC IN
socket.
2
Insert a recordable MiniDisc (page 13).
3
Press the REC button.
4
Press the MENU/ENTER button.
IM-DR420H(E) TINSE0554AWZZ
5
Press the or button repeatedly to se-
lect "Mic Level".
6
Press the MENU/ENTER button.
7
Press the or button repeatedly to se-
lect "Auto-Hi", "Auto-Lo" or "MANUAL".
" When "Auto-Hi" or "Auto-Lo" is selected, the re-
cording level is automatically adjusted according to
changes in sound volume. Normally select "Auto-
Hi". When the recording level frequently reaches
"OVER", switch to "Auto-Lo" to lower the level. Set
the maximum level between "-4 dB" and "0 dB".
" The automatic level adjustment may be delayed
by a few seconds where source sounds show
sudden and rapid changes (especially in meet-
ings and conversations). In this case adjust the
recording level manually (see page 30).
8
Press the MENU/ENTER button.
The mode will be set automatically after 7 seconds
even if the MENU/ENTER button is not pressed.
9
Select the recording mode (steps 1 - 5,
page 24).
10
Press the button.
Recording will start.
03/7/21 IM-DR420H_UK_4.fm
IM-DR420H
5
6
5
4
3
2
1
29