Irc Programming; Setting The Machine Numbers - Master And Satellite - Sharp UP-820F Instruction Manual

3

IRC Programming

To start IRC programming, first, turn on the machines in the IRC system and put them in the PGM2 mode.
The programming procedures for both the master and satellites will be explained below.
For the setup of your IRC system, please be sure to consult your authorized SHARP dealer.
1. Setting the machine numbers – master and satellite
It is necessary to assign machine numbers to the master and satellites before programming.
• In an IRC network, each machine number must be unique. Do not use the same number for
NOTE
two or more machines.
• Be sure to set up satellites first to allow the downloading of inline preset from the master to
satellites.
38
1.
Enter the PGM2 mode from the mode selection window.
2.
Select "SETTING" and press the
The SETTING window will appear.
3.
Select "TERMINAL" and press the
The TERMINAL window will appear.
4.
Move the cursor to the "MACHINE#" line.
Enter a machine number and press the
Machine number: up to 6 digits (0–999999)
5.
Repeat steps 1 to 4 for all machines in the IRC system.
e
key.
e
key.
c
key.