Chapter 4. Srv Mode Programming ("3 Irc Setting") - Sharp UP-600 Programming Manual

CHAPTER 4. SRV MODE PROGRAMMING ("3 IRC SETTING")

Before trying to perform inline setup, make sure to create (or delete)
the files required by the inline system using the following procedure:
[SRV MODE] - [2 SETTING] - [08 FILE]. And then perform inline
setup.
DISPLAY: SRV mode screen
Select "3 IRC SETTING" and press the ENTER key.
DISPLAY: IRC SETTING item selection screen
Select the item and press the ENTER key.
The item setting input screen is displayed.
1. [1 TERMINAL SETTING]
DISPLAY: Setting item selection screen
Select the item to be changed and press the ENTER key.
The contents of setting are shown in the table below.
[1 SATELLITE]
DISPLAY: Setting screen
Select the item to be changed and press the ENTER key.
The setting content is described below.
DISPLAY
CONTENTS
TEXT
IP ADDRESS 1
IP ADDRESS 2
IP ADDRESS 3
IP ADDRESS 4 Terminal No.
GLU GLU system
POSITIVE Positive #
system
NEGATIVE Negative #
system
BACKUP Backup
MASTER master function
Regarding IP address 1-3, use the same address for all machines
(master, back-up master, and satellites) on the inline system.
For IP address 4, enter the terminal No. on the inline system.
When all the machine are set, press the [CA/AT] key.
The [IRC SETTING] screen appears to start the setup.
DISPLAY:
IRC SET UP
1: SAVE FILE DELETE
2: OTHER FILE DELETE
3: SAVE FILE NON CREATE
4: OTHER FILE CREATE
SELECT ITEM MRS
192
168
000
001-254 000
CENTRALIZED CENTRALIZED
INDIVIDUAL
CENTRALIZED CENTRALIZED
INDIVIDUAL
CENTRALIZED CENTRALIZED
INDIVIDUAL
EXIST NOT
NOT