Fujitsu P2110 Manual page 36

Hot-swapping
To hot-swap Flexible Bay devices while the system is powered on, follow these steps:
1 Prior to performing the hot-swap, make sure you have a charged main battery installed, or an
AC Adapter is powering the system.
2 If your system is in Suspend mode, press the Suspend/Resume button to resume operation.
3 Click the Unplug or Eject Hardware icon (Windows 2000 Professional) or the Safely Remove
Hardware icon (Windows XP Home) in the lower right-hand corner of the screen.
4 From the list that appears, click the device you want to remove.
5 Pull out the Flexible Bay eject lever. This will push your device out slightly, allowing you to remove
the device.
6 Slide your device out until it is clear of the bay.
This will require light force.
7 Press the Suspend/Resume button so that the computer goes into suspend state.
CAUTION
Be careful when aligning and seating devices in the bay. If the fit is incorrect, you may damage
the bay or the device. If the device does not move easily in the bay, remove it, and check for dirt
or foreign objects. It will require a firm push to latch the device in place.
8 Slide the device you are installing into your notebook until it clicks into place.
9 It is now safe to turn your notebook back on.
10 You can now access and use the device.
Your LifeBook notebook will automatically detect the new device and activate it within your system.
The drive letters associated with the device will be created and listed under My Computer and Windows
Explorer.
19