Sharp AR-C250 Operation Manual page 153

FINISHER (AR-FN4)
Staple cartridge replacement
When the staple cartridge is empty, the message "SLIDE THE
FINISHER AWAY FROM THE COPIER AND ADD STAPLES." will
appear.
Replace the staple as follows:
7-22
While holding the finisher release lever, slide the finisher
1
away from the copier.
Pull out the staple box.
2
To prevent bumping or scraping your hand during removal of the
staple box, proceed as shown in the illustration and as follows:
Grasp the staple box with your thumb and index finger, and place
the heel of your hand against the finisher frame as shown with
arrow in the illustration.
1
Remove the staple box in the direction of the arrow
squeezing with your fingers and rotating against the heel of your
hand.
Remove the empty staple cartridge from inside the
3
staple box.
Insert the new staple cartridge into the box until it clicks
4
in place.
Insert the new cartridge by aligning the arrows on the cartridge
with those on the box. Check that the cartridge locks in place by
pulling it slightly.
The cartridge holds 3,000 staples.
NOTE:
Be sure to remove the rear paper and tape before inserting the
cartridge.
by
2