Table of Contents
Advertisement
Problem
Copies are smudged
or dirty.
Paper size for a paper
tray cannot be set.
Power is on but copying
is not possible.
Original table or document
feeder cover dirty?
Original smudged or blotchy?
Is the
indicator on?
Is the
indicator on?
Is the COPY indicator off?
Is copying, printing or facsimile
printing being performed?
Is the POWER SAVE indicator
blinking?
Is only the POWER SAVE
indicator on? (when an optional
printer or facsimile expansion kit
is installed)
Is the COPY indicator off?
Is
steadily lit in the copy
quantity display?
Is the
indicator on?
COPY/FAX key
The COPY/FAX key is used to switch
between the FAX and COPY modes.
For details, see the MULTI ACCESS
manual.
COPIER TROUBLE?
Solution
Clean regularly. See page 60.
Use a clean original.
Developer is reguired. Contact your SHARP
service center as soon as possible. See page
50.
Maintenance is required. Contact your SHARP
service center as soon as possible. See page
50.
Use the COPY/FAX key to select the COPY
mode. See Note below.
Set the paper size after copying, printing or
facsimile printing is complete.
Wait until warm-up is complete.
Warm-up time is approximately 35 seconds.
The copier is in the auto power shut-off mode.
Press the START key. See page 58, POWER
SAVE MODES.
Use the COPY/FAX key to select the COPY
mode. See Note below.
The copier is in the auditing mode.
Enter your account number using the numeric
keys. See page 13.
Paper is needed. See page 10, LOADING
COPY PAPER.
63
Advertisement
Table of Contents
