Sharp AL-1215 Operation Manual page 50

Using the SPF/RSPF
The SPF/RSPF is designed to hold up to 30 originals measuring from 5-1/2" x 8-1/2"
to 8-1/2" x 14" and weighting from 14 lbs. to 23.9 lbs. (52g/m
• Before feeding originals in the original feeder tray, be sure to remove
• Before placing curled or wavy originals into the original feeder tray, be
• The SPF/RSPF (
• Badly damaged originals may misfeed in the SPF/RSPF. It is
• Special originals such as transparency film should not be fed through
• Image loss (max. 5/32" (4mm)) can occur at the leading and trailing
• To stop continuous copying using the SPF/RSPF, press the clear
• Copying using one-sided to one-sided mode (AL-1551CS):
1
Make sure that no original is left on the original table.
2
Adjust the original guides to the size
of originals.
3
Set the originals face up in the
original feeder tray.
Stream feeding mode
The stream feeding mode allows easy operation of continuous copying from the
SPF/RSPF. If the stream feeding mode has been enabled using user program No.4,
the SPF/RSPF (
original has been fed by the SPF/RSPF. While this indicator is blinking, any new
originals placed in the original feeder tray will be fed and copied automatically. If the
stream feeding mode has been disabled, the start (
time the originals are set even immediately after completion of a copy run from the
SPF/RSPF. The default setting of the stream feeding mode is "ON". See "USER
PROGRAMS" (p.55).
48
any staples or paper clips from them.
sure to flatten them. If not, original misfeeds may result.
this indicator does not light up, the originals are not properly set or the
SPF/RSPF is not properly closed.
recommended that such originals be copied from the original table.
the SPF/RSPF, but should be placed directly on the original table.
edges of the copies. Also image loss (max. 11/64" (4.5mm) in total)
can occur along the other edges of the copies. It can be 15/64" (6mm)
(max.) at the trailing edge of the second copy of two-sided copying.
( ) key.
Ensure that no indicator is lit among the original to copy indicators.
) indicator will blink approximately 5 seconds after the last
) indicator on the operation panel will light up. If
2 2
to 90g/m ).
Original face up
) key must be pressed each