Making Copies; Copy Flow - Sharp AL-1215 Operation Manual

5
This chapter explains basic and other copying functions.
The unit is equipped with a one-page memory buffer. This memory allows the unit to
scan an original once only and make up to 99 copies. This feature improves
workflow, reduces operation noise from the copier, and provides higher reliability by
reducing wear and tear on the scanning mechanism.

COPY FLOW

1 Make sure that paper has been loaded in the paper tray (p.15)
or multi-bypass tray (p.17), and check the paper size (p.14).
If paper is not loaded, see page 15. If you are using the single bypass,
check the paper size and then proceed to the next step without loading
paper.
2 Place the original.
If you are using the original table, see "Using the original table" (p.47).
If you are using the SPF/RSPF, see "Using the SPF/RSPF" (p.48).
When copying onto paper larger than 8-1/2" x 11" size, pull out the paper
output tray extension.
3 Select the copy settings.
If you wish to copy using the initial settings (p.13), proceed to the next step.
To set the number of copies, see page 49.
To adjust the resolution and contrast settings, see page 49.
To enlarge or reduce the copy, see page 51.
AL-1551CS model
To print on both sides of the paper, see page 52.
To change the tray used, see page 53.
4 Start copying.
Press the start (
46

MAKING COPIES

If you are using the single bypass
) key.
Do not press the start (
sheet of paper into the single bypass.
(Page 18)
Multiple copies are not possible
using the single bypass.
) key. Insert a