Bypass Feed (Including Special Paper) - Sharp AL-1045 Operation Manual

BYPASS FEED (including special paper)

The multi-bypass tray (AL-1555) or the single bypass (AL-1045/AL-1255/AL-1456) can be used
to feed standard paper, transparency film, labels, envelopes, and other special purpose paper.
Paper measuring from A6 to A4 and in the weight range of 52 to 128g/m
tray. (For paper weighing from 104 to 128g/m
• The multi-bypass tray (AL-1555) can hold maximum of 50 sheets of
paper. (Capacity will vary depending on the type of paper loaded.) The
single bypass (AL-1045/AL-1255/AL-1456) can hold one sheet of paper.
• The original image must be smaller than the paper or media for
copying. If the original image is bigger than the paper or media, this
may cause smudges on the edges of the copies.
The multi-bypass tray (AL-1555)
1
Open the multi-bypass tray and extend the tray.
To close the multi-
bypass tray, perform
step 1 and then step 2 in
the illustration and push
the round projections at
the right of the tray until
they click.
2
Set the paper guides to the paper width. Insert the paper (print
face down) all the way into the multi-bypass tray.
• Paper must be fed narrow side into the feed slot.
• Transparency film, labels, and other special purpose papers must
be fed individually.
• When copying onto transparency film, remove each copy promptly. Do not let
copies stack up. When loading an envelope, make sure that it is straight and flat.
3
Press the tray select (
2
, A4 is the maximum size.)
) key to select the multi-bypass tray.
2
can be used in this
Print face
3
17