Table of Contents
Advertisement
Menu Bar Code Security Settings
Honeywell scanners are programmed by scanning menu bar codes or by sending
serial commands to the scanner. If you want to restrict the ability to scan menu
codes, you can use the Menu Bar Code Security settings. Please contact the nearest
technical support office (see
tion.
Setting Custom Defaults
You have the ability to create a set of menu commands as your own, custom
defaults. To do so, scan the Set Custom Defaults bar code below before scanning
the menu commands for your custom defaults. If a menu command requires scan-
ning numeric codes from the back cover, then a Save code, that entire sequence
will be saved to your custom defaults. When you have entered all the commands
you want to save for your custom defaults, scan the Set Custom Defaults bar code.
Set Custom Defaults
You may have a series of custom settings and want to correct a single setting. To
do so, just scan the new setting to overwrite the old one. For example, if you had
previously saved the setting for Beeper Volume at Low to your custom defaults,
and decide you want the beeper volume set to High, just scan the Set Custom
Defaults bar code, then scan the Beeper Volume High menu code, and then Save
Custom Defaults. The rest of the custom defaults will remain, but the beeper vol-
ume setting will be updated.
Resetting the Custom Defaults
If you want the custom default settings restored to your scanner, scan the Activate
Custom Defaults bar code below. This is the recommended default bar code for
most users. It resets the scanner to the custom default settings. If there are no
custom defaults, it will reset the scanner to the factory default settings. Any set-
tings that have not been specified through the custom defaults will be defaulted to
the factory default settings.
Vuquest 3320g User Guide
Technical Assistance
Activate Custom Defaults
on page xiii) for further informa-
Save Custom Defaults
5
Advertisement
Table of Contents
Troubleshooting
