Adjusting The Audio Channels; Daisy Chaining Audio Signals - Sennheiser evolution wireless ew 300 IEM G3 Instruction Manual

A
Loop Out
BAL
+22dBu BAL
MAX
AF IN
L(I) R(II) L(I) R(II)
+22dBu MAX RF OUT
B
Loop Out
BAL
+22dBu BAL
MAX
AF IN
L(I) R(II) L(I) R(II)
+22dBu MAX RF OUT
C
Loop Out
BAL
+22dBu BAL
MAX
AF IN
L(I) R(II) L(I) R(II)
+22dBu MAX RF OUT
Easy Setup Sync
–

Adjusting the audio channels

Via the "Mode" menu item, you can adjust the audio channels.
Select "Stereo" if you want to transmit two separate audio signals on channel I and
channel II (e.g. channel I = audio signal of the presenter/musician, channel II = sum of all
audio signals).
This allows the presenter/musician to adjust the balance between the left and right
stereo signal on his receiver.
Select "Mono" if you only want to transmit an audio signal on one channel. In this case,
the signal from the left audio input
During mono operation, you have to deactivate the pilot tone evaluation on the
EK 300 IEM G3 receiver in order to ensure that your receiver outputs the same signal
on channel I and II.

Daisy chaining audio signals

The output sockets LOOP OUT BAL L
signal that is to be transmitted to all receivers from the mixing console to one transmitter
and then to the other transmitters.
To daisy-chain an audio signal from one transmitter to the next:
Route a signal from the mixing console to the input socket (in this example:
BAL AF IN R ) of transmitter A.
Connect the output socket
BAL AF IN R of transmitter B.
Connect the output socket
BAL AF IN R of transmitter C.
Repeat for the other transmitters.
You can use the output sockets
only when the transmitter is switched on (see page 11).
Sync
To cancel the transfer:
Press the
mitter.
" " appears on the display panel of the
transmitter. " " also appears if no suit-
able receiver was found.
BAL AF IN L is transmitted.
and/or LOOP OUT BAL R
LOOP OUT BAL R of transmitter
LOOP OUT BAL R of transmitter
LOOP OUT BAL L(I)
Using the transmitter
STANDBY button on the trans-
allow you to daisy chain a
A to the input socket
B to the input socket
and/or LOOP OUT BAL R(II)
17