Using The Transmitter; Switching The Transmitter On/Off - Sennheiser evolution wireless ew 300 IEM G3 Instruction Manual

Using the transmitter

To establish a transmission link, proceed as follows:
1. Switch the transmitter on (see below).
2. Switch the receiver on (see the instruction manual of the receiver).
The transmission link is established.
It is vital to observe the notes on frequency selection on page 21.
If you cannot establish a transmission link between transmitter and receiver:
Make sure that transmitter and receiver are set to the same frequency bank and to the
same channel.
If necessary, read the chapter "If a problem occurs ..." on page 23.

Switching the transmitter on/off

To switch the transmitter on
Press the STANDBY
The transmitter switches on and the standard display appears.
The transmitter transmits an RF signal and the transmission icon
You can switch the transmitter on and deactivate the RF signal on switch-on.
For more information, see below.
To switch the transmitter to
If necessary, deactivate the lock mode (see page 18).
Keep the STANDBY
The display panel switches off.
When in the operating menu, pressing the
(ESC function) and return you to the standard display.
The STANDBY button
To completely switch the transmitter off:
Disconnect the transmitter from the mains by unplugging the mains unit from the wall
socket.
The backlighting of the
To switch the transmitter on
Press the STANDBY
Press the jog dial.
The transmission frequency is displayed but the transmitter does not transmit
an RF signal. The transmission icon
(online operation):
.
button
standby mode:
button pressed until "OFF" appears on the display panel.
STANDBY
is backlit in red both during operation and in standby mode.
STANDBY button goes off.
and to deactivate the RF signal on switch-on
button until "RF Mute
is not displayed.
Using the transmitter
is displayed
button will cancel your entry
(offline operation):
On?" appears on the display panel.
13