Using The Receiver; Switching The Receiver On/Off - Sennheiser EM500 Instruction Manual

Using the receiver

20
Using the receiver
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see next section).
2. Switch the transmitter on (see the instruction manual of the trans-
mitter).
The transmission link is established and the display backlighting of the
receiver changes from red to orange.
It is vital to observe the notes on frequency selection on page 45.
If you cannot establish a transmission link between transmitter and
receiver:
Make sure that transmitter and receiver are set to the same frequency
bank and to the same channel.
Read the chapter "Synchronizing transmitters with receivers" on
page 45 and, if necessary, the chapter "If a problem occurs ..." on
page 51.

Switching the receiver on/off

To switch the receiver on:
Briefly press the
The receiver switches on and the
standard display appears.
To switch the receiver to
PEAK B.Ch: 20.30
ew500 G3
40 0
-10 542.625
MHz
30
-20
20
-30
EQ SKM500
10
-40
P P + 12dB
RF AF
STANDBY button .
standby mode:
"Receiver Parameters"