Table of Contents
Advertisement
9
9
9
DC IN
12V/150mA
LEV 6dBu MAX
DC IN
LEV 6dBu MAX
12V/150mA
8
To mount two central units into a rack:
Place the two central units side by side upside-down onto a flat surface.
9
Align the jointing plate
units.
Secure the jointing plate
recessed head screws (M 3x6).
Hook the two rack mount "ears"
0
Secure the rack mount "ears" to the central units using two of the sup-
plied recessed head screws (M 3x6) respectively.
Slide the central units into the 19" rack.
Secure the rack mount "ears" to the rack.
To mount only one central unit into a rack:
Hook the two rack mount "ears"
8
Secure the rack mount "ears" to the central unit using two of the supplied
recessed head screws (M 3x6) respectively.
A
Secure the blanking plate
of the supplied recessed head screws (M 6x10).
If you are not front mounting the BNC output connector, insert the two
blanking plugs
Slide the central unit into the 19" rack.
Secure the rack mount "ears" to the rack.
Connecting the mains unit
Connect the supplied mains unit to the socket
grip
AF OUT
BAL/UNBAL
Connect the suitable adapter to the mains unit
Connect the mains unit
The device switches on automatically.
Connecting the amplifier
The audio outputs are available as a balanced XLR-3M output
unbalanced BNC output
devices (amplifier, etc.). Both outputs deliver the same output voltage, are
AF OUT
BAL/UNBAL
short-circuit proof and decoupled from each other.
Connect the amplifier/mixing console to the balanced XLR-3M output
or the unbalanced BNC output
For details on balanced or unbalanced connection, see "Connector assign-
ment" on page 15.
over the holes in the bottom sides of the central
to the central units using eight of the supplied
to one of the rack mount "ears"
into the holes of the blanking plate.
to secure the power supply DC cable.
to the mains.
, allowing you to simultaneously connect two
the front panels of the central units.
to the front panel of the central unit.
(DC IN). Use the cable
.
.
using two
and an
Advertisement
Table of Contents
