Precor Crosstrainer 800 Assembly Manual page 8

To install the side covers:
1. For 800 EFX only: Lift up the lower frame cover about an inch from the frame.
IMPORTANT
Although there are two screw holes in the frame cover, DO NOT install these
screws.
Figure 5
2. Secure each side panel using four self-tapping screws
Figure 6
3. Tighten the fasteners to 35 in-lb (3.95 N-m) of torque.
4. Repeat steps 2 and 3 to attach the second side panel.
5. For 800 EFX only: Press the side panels into place ensuring the latches under
each panel are secured.
Notes for 800 EFX
• Make sure cables don't catch on the latch of the forward frame cover (see Figure
7) and are tied to the outside and away from the screw (see Figure 8).
• Make sure the
right and left side panels (see Figure 7). Use finesse not force to secure the parts
together with no gap between them.
B
for each panel.
Figure 7
B A
clips on the lower frame cover hook over the
A
Figure 8
B
clips on the
9