Advertisement
Install the console mount
WARNING
DO NOT attempt to connect electrical power until all assembly
procedures are complete and properly installed.
For non-touchscreen consoles:
1.
Locate the communication cable that is bundled and attached to the EFX
frame.
2.
Thread the communication cable upward through the center of the console
mount and out the opening at the top of the mount.
3.
Position the display mount on top of the base frame (Figure 1) and attach it
using four bolts
. Tighten all bolts to 180 in-lb (20 N-m) of torque.
For touchscreen consoles:
1.
Retrieve the power, coax, and Ethernet cables from the console box.
2.
Group all four cables—communication, coax, power extension supply, and
Ethernet—and thread them upward through the center column and out
through the center opening in the console mount. Tape them to the top of the
console mount to secure them temporarily.
IMPORTANT
DO NOT stretch, crimp, or damage the cables. Cables damaged by improper
installation are not covered by the Precor Limited Warranty.
3.
Position the display mount on top of the base frame (Figure 1) and attach it
using four bolts
. Tighten all bolts to 180 in-lb (20 N-m) of torque.
Figure 1
6
Advertisement
