Calling Up The Web Server Of The Access Point - Sennheiser WiCOS Instruction Manual

After the reset, the following factory default settings are loaded:
Configuration
Network settings
(IP address)
Password protection
RF signal strength ("Room size")
Radio frequency
Country settings for radio communication
("Country selection")
Max. number of simultaneously
active microphones
Conference mode
Loudspeaker volume
Number of interpretation channels
Operating mode of the chairman units
WiCOS C and WiCOS CV
Operating mode of the access point
Initialization mode of the conference
units
Encryption mode

Calling up the web server of the access point

In order to be able to call up the web server of the access point, you require
a computer with network connection (RJ 45) and a web browser.
Make sure that the access point is correctly connected to your
computer or network via the network socket (RJ 45) h.
Setting the computer to the address range of the access point
In order to access the web server the first time, you have to set your
computer to the address range of the access point.
You only require the fixed IP address of your computer in order to
access the web server for the first time. Via the web server, you can
adapt the IP address of the access point to match the ones in your
network.
Configuring the conference system
Factory default setting
System name: "WiCOS"
IP address mode: "Static"
IP: "192.168.0.10"
Subnet: "255.255.255.0"
"123"
"Big"
"Automatically"
"US/Canada"
"4"
"Direct Access"
"6"
"0"
"Volume Control"
"Stand Alone"
"Open Access"
"Use default key"
45