Switching The Components On/Off; Switching The Access Point On/Off - Sennheiser WiCOS Instruction Manual

Switching the components on/off

To switch the WiCOS conference system on, proceed as follows:
1. Switch the access point on (see next chapter).
2. Switch the conference units on (see page 31).
The connection is automatically established. The conference system
loads the last configuration used (see next chapters).

Switching the access point on/off

To switch the access point on:
Set the on/off switch
The last configuration used is loaded. The 3 status indicators
m
provide the following information:
Blue LED 1
`
flashes slowly
lights up
Red LED 2
^
off
flashes slowly
flashes rapidly
lights up
Blue LED 3
^
flashes rapidly
lights up
You can use the factory default settings or adapt the configuration to your
needs (see page 44):
Configuration
Network settings
(IP address)
Country settings for radio
communication
Password protection
RF signal strength
Radio frequency
Switching the components on/off
m
to position "1".
Operating mode of the access point
integrated operation (slave mode)
stand-alone operation
Link quality (RF signal quality)
excellent
good
fair
low
Connection status with the conference units
no connection
connection with at least 1 conference unit
Function/Meaning
To load the web server and to
modify the configuration
To set country-specific limit
values for radio frequencies and
transmission power
To protect the web server from
unauthorized access
To set the transmission power
To set the radio frequencies to be
used in the 2.4 GHz and 5 GHz
frequency bands
^
Detailed
information
see page 49
see page 51
see page 52
see page 53
see page 53
29