Switching A Conference Unit On/Off - Sennheiser WiCOS Instruction Manual

C CV D DV
V
:
:
A
C CV D DV
U
C CV D DV
E
E
C CV D DV
7

Switching a conference unit on/off

To switch a conference unit
Press the microphone key A.
The last configuration used is loaded.
The microphone LED
connection status:
LED
off:
U
RF link indicator
0
microphone LED
flashes:
U
RF link indicator
0
microphone LED
lights up:
U
RF link indicator
When the connection is established, the multi-function display
the channel selection display
conference units switch on.
If there are several access points within the transmission range,
intermodulation can occur. In this case, use the dynamic frequency
management (see page 53) and initialize the desired conference
units on the access point (see page 76).
7
If no connection to an access point can be established within
2 minutes, the conference unit automatically switches off.
The following last used configurations are loaded. You can use the factory
default settings or adapt the configuration to your needs (see page 44):
Configuration
Country settings for
radio communication
RF signal strength
Radio frequency
Loudspeaker volume
Operating mode of the
chairman units
Switching the components on/off
on :
0
and the RF link indicator
Connection status with the access point
connection is established
,
connection is being established
: blue
: red green
malfunction
: blue
E
of the WiCOS DV and WiCOS CV
Function/Meaning
To set country-specific limit values
for radio frequencies and
transmission power
To set the transmission power
To set the radio frequencies to be
used in the 2.4 GHz and 5 GHz
frequency bands
To set the volume of the conference
units' loudspeakers
To set the function of the selection
9
8
key A and B
U
display the
7
and
Detailed
information
see page 51
see page 53
see page 53
see page 59
see page 65
31