Checking Generator Drive Plate Torque - Generac Power Systems MAGNUM MMG25IF4 Operating Manual

Diesel generator with power zone controller

Hide thumbs

Table Of Contents

Table of Contents

Maintenance

To perform additional maintenance alarm resets, repeat steps 6 - 8.

Note: If the selected maintenance alarm does not need to be reset, press  to highlight "Not Reset" and press ()

return to the parameters section.

To save changes, press and hold () for five seconds. To discard changes made, press and hold (O) for five

10.

seconds.

EXHAUST FILTER SERVICE REQUIREMENTS

The exhaust filter system contains a Diesel Particulate Filter (DPF). Over time, the DPF will require professional

servicing to remove ash buildup. The expected service interval will be at least 3,000 or 4,500 hours, based on engine

power and operating conditions. Actual service should take place when the indicator light appears on the Power

Zone™ controller. The DPF should be cleaned or replaced by an authorized service provider only. The removal of

DPF ash must be done by removing the DPF from the unit and placing it into specialized equipment.

Do not remove ash by using water or other chemicals. Removing ash by these methods

may cause equipment damage and create unsafe operating conditions.

Only a qualified service provider should remove, handle and dispose of DPF ash. These

materials may be considered hazardous under federal, state and local regulations, and must

To avoid unnecessary buildup of diesel particulates or soot in the exhaust filter system:

•

Utilize the Automatic Exhaust Filter Cleaning mode.

•

Avoid unnecessary idling.

•

Use proper engine oil. Refer to the engine operator's manual.

•

Use only ultra low sulfur diesel fuel. Refer to the engine operator's manual.