Assembly - Ryobi GD200 Operator's Manual

NOTE: Many of the illustrations in this manual show only
portions of the garage door opener. This is intentional
so that we can clearly show points being made in the
illustration. Never operate the garage door opener
without all parts securely in place and in good operating
condition.
ASSEMBLING THE RAILS
See Figures 8 - 10.
 Locate the following items:
End Rail
Intermediate Rail
Front Rail
Sleeves (2)
 Insert the edge of the end rail into a sleeve. Slide together
until rail clicks in place. If you cannot get the rail to fit by
hand, try gently tapping it with a rubber mallet until it is
snug.
NOTE: Be careful not to pinch the belt between the rail
and the sleeve during assembly.
 Repeat this process to attach the intermediate and front
rails.
 Once assembled correctly, the rails should not separate
easily when pulled.
Sleeve
Belt
Sleeve
Front
Rail

ASSEMBLY

End
Rail
Fig. 8
Intermediate
Rail
Fig. 9
Sleeve
Fig. 10
ADJUSTING THE BELT TENSION
See Figures 11 - 14.
 Pull the release lever down and move carriage (trolley)
away from the bullet to make sure they are not engaged.
 Locate the tension nut on the end of the front rail.
Bullet
Carriage
(Trolley)
Carriage
(Trolley)
Front
Rail
15 - English
Release
Lever
Bullet
Fig. 11
Tension
Nut
Fig. 12