Prepare The Bobbin; To Remove The Bobbin Case From The Machine; Wind The Bobbin - Kenmore 385.12514 Owner's Manual

Prepare the Bobbin
= To Remove the Bobbin Case from the Machine
Remove the extension tabte from
the machine by pulling it to the left.
Open the shuttIe cover by pulling
down the embossed part on the left
side of the cover.
Raise needle to its highest position
by rotating hand whee! toward you.
J
To remove bobbin case from shuF
tie, pull open latch of bobbin_case,
Pul] bobbin case straight out ol
shuttle
SECTION 2. PREPARE THE MACHINE FOR SEWING
o Wind the Bobbin
Release clutch by turning the clutch
knob inside the hand wheel toward
you to stop the needle trom moving
while you wind the bobbin.
k.
NOTE:
\
fJ
The bobbin winder stopper can be adjusted lor the amount of thread needed
on the bobbin (example 1/2 full or full etc.). To make the adjustment use your
large screw driver and loosen the screw one turn or less. This will allow you
to adjust the position of bobbin winder stopper. Do not take screw all the
wayout.