Printer Speed Selection; Using A Computer (Rs232 Operating Commands) - Hach 2100N Instruction Manual

Tài li u sưu t m c a Trung Sơn - www.tschem.com.vn - 028.3811.9991 - info@tschem.com.vn
SECTION 6,
continued
Foreign
Character
Selection
Parity
Check
Data
Baud
Rate

6.2.1 Printer Speed Selection

6.3 Using A Computer (RS232 Operating Commands)

Tài li u sưu t m c a Trung Sơn - www.tschem.com.vn - 028.3811.9991 - info@tschem.com.vn
Table 4 Dip Switch Settings for the Citizen Printer
USA
DSW1-4 OFF
DSW1-5 OFF
ODD
DSW1-6 OFF
DSW1-7 OFF
DSW1-8 ON = 7 Bit
9600
DSW1-9 OFF
DSW1-10 OFF
1. The 2100N Turbidimeter can be configured for fast or slow (2.5 second delay)
print speed.
2. Press and hold the
3. Use the
ARROW
4. Press the
ENTER
5. Use the and
UP
for fast print speed.
FS Pr
6. Press the
ENTER
configuration mode.
A communication program such as Window Terminal or ProComm Plus is
recommended for computer operation. Configure the communication program to
1200 baud, 8 data bits, no parity, 1 stop bit.
The following RS232 command set is available when a computer is connected to
the 2100N:
•
Key in VAL (for value) and press enter on the computer keyboard. This action
recalls the current 2100N measurement with the measurement units.
•
Key in LST (for list) and press enter on the computer keyboard. This action
lists the calibration standards and coefficients.
Germany France
OFF ON
ON OFF
EVEN
ON OFF
OFF ON
4800 2400
OFF ON
ON OFF
key for 3 seconds.
RIGHT ARROW
keys to edit the display to read
key to activate the print speed selection mode.
keys to select the flashing
DOWN ARROW
key to accept the desired setting, and exit the print speed
66
UK
ON
ON
NO CHECK
ON
ON
OFF = 8 Bit
1200
ON
ON
.
01
for slow or
SL Pr