Installing The Drain Receiver And The Head Support Rubber; Safety Switch - JUKI LK-1900S Series Instruction Manual

3-8. Installing the drain receiver and the head support rubber

3-9. Safety switch

DANGER:
When using the safety switch without removing tape ❶ , it is very dangerous since the sewing ma-
chine works even in the state that it is tilted.
Remove tape ❶ fixing the lever section of safety switch ❷ .
In case error 302 occurs when the sewing machine works after setup, loosen the safety switch ❷
fitting screw with a screwdriver, and lower the switch to the downside of the sewing machine.
1) Fix drain receiver ❷ in the installing hole of table
❶ with two setscrews ❸ .
2) Screw poly-oiler ❹ in waste oil reservoir ❷ .
3) Insert sewing-machine waste oil pipe ❺ into po-
ly-oiler ❹ .
4) Insert head support rubber ❻ into table ❶ .
5) Pass bundle ❼ of cords through slotted hole ❽
in the table.
1. Insert drain pipe ❺ until it will go no fur-
2. Remove the tape fixing drain pipe ❺ .
❶
❷
－ －
8
ther so that it does not come off drain
bin ❹ when tilting the machine head.
❷