Page 1
Additional manuals are available from your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment.
The for information and other details concerning warranty. prices charged by Wells Bloomfield for its products are SERVICE POLICY AND PROCEDURE GUIDE and ADDITIONAL WARRANTY EXCLUSIONS Resetting of safety thermostats, circuit breakers, over cleaning schedules, are customer responsibility.
PARTS & SERVICE CUSTOMER SERVICE DATA INTRODUCTION Thank You for purchasing this Wells Manufacturing Co. appliance. Proper installation, professional operation and consistent maintenance of this equipment will ensure that it gives you the very best performance and a long, economical service life.
FEATURES & OPERATING CONTROLS PERFORATED BASE PLATE WATER FILL SPOUT WATER LEVEL SENSOR HEATING ELEMENT DRAIN SCREEN TEMPERATURE SENSING BULB WELLSLOKS DRAIN CONNECTION WATER SUPPLY INLET (ON BACK OF CONTROL BOX) BACK-FLOW PREVENTER "HEATING" INDICATOR WATER FILL TUBE TEMPERATURE CONTROL KNOB ELECTRICAL SUPPLY INLET NAMEPLATE...
Damage Do not operate this appliance if the control panel is damaged. Call to the appliance may result if your Authorized Wells Service Agent for service. these instructions are not followed. The technical content of this manual, including any wiring diagrams, schematics, parts breakdown illustrations and/or adjustment procedures, is intended for use by qualified technical personnel.
INSTALLATION NOTE: DO NOT discard UNPACKING & INSPECTION the carton or other packing materials until you have Carefully remove the appliance from the carton. Remove all inspected the appliance for protective plastic film, packing materials and accessories from the hidden damage and tested it appliance before connecting electrical power or otherwise performing for proper operation.
Page 7
INSTALLATION (continued) ELECTRICAL INSTALLATION CAUTION: SHOCK HAZARD IMPORTANT: Appliance must be installed by a licensed electrician in accordance with all applicable codes and ordinances. The ground lug of this appliance must be connected Refer to the product nameplate. Verify the electrical service power. to a suitable building ground.
OPERATION CAUTION: OPERATION HOT SURFACE Make sure the drain valve is fully closed. Install DRAIN SCREEN and Exposed surfaces can be hot PERFORATED BOTTOM PLATE. Add at least 2 quarts (1 liter) of to the touch and may cause water to pan before turning the TEMPERATURE CONTROL KNOB burns.
Contact your Authorized Wells Service Agency to inspect rethermalizer if water or grease contamination is suspected. 5. Reinstall drain screen and perforated bottom plate.
Page 10
CLEANING INSTRUCTIONS (continued) CAUTION: WEEKLY CLEANING INSTRUCTIONS CHEMICAL BURN PREPARATIONS: Remove any insets, pans and/or adapter tops. HAZARD Drain or remove water from well if used for wet Deilimng chemicals may be operation. caustic. Wear appropriate personal protective equipment. FREQUENCY: Weekly, or whenever lime or scale is seen Follow cleaner manufacturer's accumulating on the sides of the warmer pans.
Rethermalizer slow to heat Verify supply voltage - must match Connected to wrong voltage voltage on rethermalizer nameplate There are no user-serviceable components in this appliance. In all instances of damage or malfunction, contact your Authorized Wells Service Agency for repairs.
For factory authorized service, or to order factory authorized replacement parts, contact your Wells authorized service agency, or call: Wells Bloomfield, LLC 10 Sunnen Drive St. Louis, MO 63143 Service Parts Dept.
Page 16
Created for WELLS BLOOMFIELD, LLC 10 Sunnen Dr., St. Louis, MO 63143 telephone: 800-807-8054 fax: 314-781-2714 www.wells-mfg.com...