Receiver And Remote Control Programming - Craftsman 139.53535SRT1 Owner's Manual

Receiver and Remote Control Programming
To comply with FCC rules, adjustment or modifications of this receiver
and/or transmitter are prohibited, except for changing the code setting or
replacing the battery THERE ARE NO OTHER USER SERVICEABLE
PARTS.
Models with 3-function remote controls: The
remote controls have been factory set to operate
with the large push button on the remote control.
However, you can use either of the two small
buttons, if you prefer. And, the 3-function remote
control can also activate additional garage door
openers and/or light controls.
Below are instructions for programming your opener
to match the other buttons on your remote controls
and any additional remote controls you may
purchase. See available accessories on page 38.
53000SRT Series Garage Door Openers
(With "SRT" Button)
Children operating or playing with a garage
door opener can injure themselves or others.
The garage door could close and cause
serious injury or death. Do not allow children
to operate the door push button(s) or remote
control(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
Figure 1
Select a remote control push
button to operate opener
Your "SRT" garage door opener will operate with as
many as four "SRT" portable remote controls and
one Multi-Function Keyless Entry.
To Add A Remote Control
1. Press and hold the selected remote control push
button, see Figure 1.
2. Then press and release the "SRT" (learn) button
on the right side panel of the opener, Figure 2.
The opener lights will flash once.
3. Release the remote push button.
Now the opener will operate when the remote
control push button is pressed.
if you release the remote control push button
before the opener lights flash, the opener will
not accept the code.
To Change the Selected Push Button
On the Same Remote control
If you decide to use a different remote control button
than originally programmed into the opener, you
must erase aft the learned codes and reprogram
each remote control used to operate the garage
door opener.
To Erase All Remote control Codes
* Press and hold the "SRT" button on the opener
panel until the indicator light turns off (about 6
seconds). All the codes the opener has learned
will be erased.
* To reprogram, repeat Steps 1, 2 and 3 for each
remote control in use.
Code programming instructions are also located
on the opener panel.
3-Function
Remote Control
Figure 2
/
"SRT" (learn) Indicator
Button Light
Garage Door Opener
(With "SRT" Button)
RIGHT
PANEL
To Add the Keyless Entry
We recommend that you program your code before
you install the Keyless Entry. You will not need
assistance, and you can test the reception at the
mounting location before installation.
1. Choose a 4-digit code using numbers from 0 to 9.
You can use a number more than once (for
example, 4, 0, 4, 1). Press the selected code digits
on the keypad.
2. Press and hold the Enter button while you press
the "SRT" (learn) button on the opener panel. The
indicator light will blink and the door will begin to
move.
3. Release the Enter button. Now the opener has
learned the selected keypad code.
To ensure that your portable remote control codes
were not disturbed while you were programming the
Keyless Entry, test your remotes and reprogram them
if necessary.
To change the code at any time, repeat steps 1-3.
33