Menu Parameter Descriptions; Utilities Menu - Shure Axient Digital User Manual

Menu Parameters
The Main menu organizes the available transmitter parameters into three
categories:
• Radio
• Audio
• Utilities
Radio
Tips for Editing Menu Parameters
• To access the menu options from the home screen, press O . Use the arrow
buttons to access additional menus and parameters.
• A menu parameter will blink when editing is enabled
• To increase, decrease or change a parameter, use the arrow buttons
• To save a menu change, press O
• To exit a menu without saving a change, press X

Menu Parameter Descriptions

Radio Menu
Freq
Press the enter button to enable editing
of a group (G:) channel (C:) or frequency
(MHz). Use the arrow buttons to adjust the
values. To edit the frequency, press the
O button once to edit the first 3 digits, or
twice to edit the second 3 digits.
Power
Higher RF power settings can extend the
range of the transmitter.
Note: Higher RF power settings decrease battery
runtime.
Output
Sets the RF output to On or Mute.
- On: RF signal is active
- Mute: RF signal is inactive
Audio Menu
Offset
Adjust Offset level to balance mic levels
when using two transmitters for frequency
diversity or when assigning multiple
transmitters to receiver slots. Adjustment
range: -12 dB to +21 dB.
Mute
When enabled, the power switch is
configured as a mute switch for the audio:
- Power switch on: audio signal on
- Power switch off: audio signal muted
Tone Gen
Transmitter will generate a continuous test
tone:
- Freq: The tone can be set to 400 Hz or 1000
Hz.
- Level: Allows for adjustment of the output
level of the test tone.
Main

Utilities Menu

Device ID
Assign a device ID of up to 9 letters or numbers.
Locks
- None: The controls are unlocked
- Power: The power switch is locked
- Menu: The menu parameters are locked
- All: The power switch and menu parameters are locked
Locks the transmitter controls and power switch.
Link Info
Displays the following information about the link between a transmitter and receiver:
- Not Linked: The transmitter is not linked to a receiver
- Linked: The transmitter is linked to a receiver. Select Unlink? to free the transmitter from the receiver link.
- Unlinked: The transmitter is not linked to a receiver
SL Test
ShowLink test tool to measure the boundaries of ShowLink coverage.
Marker
When enabled, press the enter button to drop a marker in Wireless Workbench.
Battery
Displays battery information:
- Battery: The chemistry type of for the installed battery (Shure Rechargeable, Alkaline, Lithium, NiMH)
- Bars: Indicates the number of bars displayed
- Time: Battery runtime
- Charge: Percentage of charge capacity
- Health: Percentage of current battery health
- Cycle Count: Record of the number of charging cycles for the installed battery
Talk Sw
Indicates the status of the talk switch.
About
Displays the following transmitter information:
- Model: Displays the model number
- Band: Displays the tuning band of the transmitter
- FW Version: Installed firmware
- HW Version: Hardware version
- Serial Num: Serial number
Reset All
Restores all transmitter parameters to factory settings.
Menu Map
Main Menu
10
Radio
Freq
Power
Output
Audio
O set
Mute
Tone Gen
Utilities
Device ID
Locks
Link Info
SL Test
Marker
Battery
Talk Sw
About
Reset All