Anti-Theft Coding; Language Settings - Clarion BTD3341 User Manual

Anti-theft coding

The anti-theft coding prevents the reactivation of the device electronically when it is removed by
unauthorised persons.
If "SAFE" appears on the display for approx. 10 seconds immediately after turning on the device and
then "1000" continuously, enter the code corresponding to the device to deactivate the electronic lock.
Enter the code number
After turning on the device, "SAFE" appears on the display and then, after a short period, "1000".
By pressing a function button
Thereby, the function buttons are allocated as follows:
Position Function button
X--- top left
-X-- centre left
--X- bottom left
---X top right
After entering the four digits, keep the
confirmed by an acoustic signal. Then the device is ready for operation.
Device card
The code and serial number is located on a device card supplied with the device. The device card must
be kept in a safe place. Never leave it in the vehicle. The device is only useful for thieves if they also
have the card!
Incorrect code number
If the incorrect code number is entered when disabling the electronic lock, first "SAFE" appears flashing
on the display and then "1000" again. Now the complete procedure can be repeated again. The number
of attempts already carried out will be shown to the left on the display. If an incorrect code number is
entered again, the device is blocked for approx. one hour. This means that it cannot be put into
operation for this period. The lock can be recognised by the continuous "SAFE" and the number of
attempts will be shown to the left on the display. After one hour – the device and vehicle ignition must
remain switched on for this – the display goes out and the electronic lock can be disabled again, as
previously described. The cycle – two attempts, blocked for one hour – still applies.
If the device card with code number has been lost, please contact your Volkswagen Partner.

Language settings

The display language can only be set in radio mode.
MENU
Press the button again until the current language set is displayed.
Press the respective function button for selecting the language.
Function button Language settings
ENG
English
PORT
Portuguese
ESP
Spanish
RUS
Russian
107
Page 108 3 several times, the four digit code can be entered.
button pressed until the acceptance of the code has been