General Operation; Switching On, Off Or Mute; Audio Source Selection; Audio Settings - Clarion BTD3341 User Manual

General operation

Switching on, off or mute

The device is switched on by briefly pressing the rotary knob
when inserting the vehicle key. The last audio source is played back in the previously set volume as long
as this does not exceed the maximum previously set switching on volume
By briefly pressing the rotary knob
function ("MUTE"). The microphone is temporarily switched to mute by briefly pressing
knob. Press the button again to cancel the mute function.
The device is manually switched off by pressing the rotary knob for a longer period
by turning off the vehicle ignition and removing the vehicle ignition key.

Audio source selection

AM/FM
Button selects radio mode.
CD
Button selects the internal CD drive as audio source and starts the playback.
MEDIA
Button cycles through the available data carrier in the sequence USB/IPOD, SD, AUX and
BT AUDIO and selects the one displayed. Data carriers are only displayed if a corresponding data
carrier has been inserted or a corresponding device is connected.

Audio settings

Playback volume
1
Turn the rotary knob
During setting, the value "VOL 01...31" or "VOL MIN" or "VOL MAX" is shown on the display (not during RDS
display outputs). If the rotary knob
device automatically exits the menu.

Sound and volume settings

By pressing the button , the menu EQ SET is called up. In this menu, the pre-defined sound settings
POP, ROCK, CLAS or JAZZ can be selected by pressing the corresponding function button.
The respective values are shown in the display during the setting. If the rotary knob
for a few seconds, the current setting is saved and the device automatically exits the menu.
Sound and volume settings are set and saved for each of the audio sources during data carrier playback
and radio operation.
By pressing the function button
made for sound and volume.
Function button Setting
BASS
low frequencies (Bass)
TREBLE
high frequencies (Treble)
MIDDLE
medium frequencies (Middle)
BALANCE
volume distribution left and right
FADE
volume distribution front and rear
S VOL
maximum switching on volume
Press the desired function button and perform the settings using the rotary knob
110
1
of the device switched on, you can temporarily switch on the mute
to the left to reduce the volume or to the right to increase the volume.
1
is not activated for a few seconds, the current setting is saved and the
USER
the associated submenu is called up and some settings can be
1
or by turning on the vehicle ignition or
S VOL
(see below).
1
1
or, automatically
9
is not activated
9
.
the rotary