Sharp FO-5700 Operation Manual page 170

All manuals and user guides at all-guides.com
all-FO5650.book Page 166 Friday, November 26, 1999 11:05 AM
Messages and Signals
RELAY REFUSED
REMOVE ORIGINAL(S)
SIZE ERROR
REPLACE TONER
RX DOCUMENT TRAY OFF
WAITING<MEMORY FULL>
Audible signals
Continuous tone 3 seconds
Intermittent tone 5 seconds
(3 beeps) (1 second on, 1
second off)
Rapid intermittent 35 seconds
tone (0.7 seconds on,
0.3 seconds off)
166
A relay request has been denied because your fax
number has not been entered in the relay
machine's list of permitted numbers, an auto dial
number not programmed in the relay machine was
specified, or your fax number has not been
programmed in your machine.
The original document is jammed. See the
following section, Clearing Paper Jams.
This message will be followed by one of the paper
sources in parentheses, and informs you that the
paper loaded in that source is not all the same
size.
The toner cartridge must be replaced.
The received document tray is not attached.
Attach it as explained in Connections in Chapter 1
(the tray must be attached for the fax machine to
operate properly.)
The memory has become full and scanning has
stopped during scanning of a multi-page
document. Scanning will automatically resume
when sufficient memory becomes free (for
example, after several pages are transmitted).
Indicates the end of transmission,
reception, or copying.
Indicates incomplete transmission,
reception, or copying.
Indicates that an extension phone
connected to the fax is off hook.