16. Outlet gasket
17. Discharge waste elbow
18. Waste elbow flange nut
Installing the waste disposer
1. Loosen the clamp screw to allow the mounting system to
be removed from the unit (fig.2).
2. Turn the mounting assembly over and remove the flange
ring from the track on the sink flange. Undo the three
screws holding it together. This will allow the sink flange,
mount ring, and protector ring to separate (fig 3).
Use the flat blade screwdriver as a lever if required.
https://producthelp.fisherpaykel.com/nz/Clean/Dishwashing_Accessories/GD75IA1/User_Guide_GD75IA1/02_Installation_instructions
Fig 1.2. Elbow
Fig. 2 Removing the mounting system from
the waste disposer
Fig. 3 Disassembling the mounting system
Updated: Fri, 01 Mar 2019 07:04:48 GMT
Powered by
4