Fisher & Paykel GD75IA1 Troubleshooting

Troubleshooting
If there is a problem, check the chart below to see if you can fix it. If the problem cannot be fixed or persists, call your
Authorised Repairer or Customer Care.
Problem Possible causes
No electricity at
the power outlet.
Air switch tubing
not connected
Foreign object
may be lodged
Waste
between the
disposer is
turntable and
not starting
grinding ring.
Grinding chamber
may be
overloaded with
food waste or
foreign matter.
Safety overload
button may have
tripped.
A spoon, bottle
cap or other
Abnormal
foreign object may
noise when
have fallen into
operating
the waste
disposer
Foreign object
Waste
may be lodged
disposer is
between the
jammed
turntable and
https://producthelp.fisherpaykel.com/nz/Clean/Dishwashing_Accessories/GD75IA1/User_Guide_GD75IA1/05_Troubleshooting
Check that the plug is correctly connected and power is turned on.
Check another appliance at the same outlet.
Check house fuse.
Check that the air switch, or wall switch, is correctly connected. Refer to the
'Installation Instructions'.
Turn power supply and water tap off. Rotate the turntable, using a plastic,
wooden or non-magnetic implement to dislodge the foreign object.
Turn the power and water tap off and, using a plastic, wooden or non-
magnetic implement, remove the food waste or foreign matter. Refer to the
'Operating instructions' section.
The reset overload button is a red button located externally, opposite the
power cord outlet, near the bottom of the waste disposer.
Turn power supply and water tap off. Wait until grinding blades and
turntable has stopped turning. Use a plastic, wooden or non-magnetic
implement to remove the foreign object.
Turn power supply and water tap off. Rotate the turntable, using a plastic,
wooden or non-magnetic implement to dislodge the foreign object.
What to do
Updated: Fri, 28 Feb 2020 09:47:46 GMT
Powered by
1