Table of Contents
Advertisement
TCP/ IP Configuration,
Windows 2000
Follow these steps to install and configure the
TCP/IP protocol for Windows 2000 environments.
1. Click Start, select Settings, and choose
Network and Dial-up Connections. The
Network and Dial-up Connections window
opens.
2. In the Network and Dial-up Connections
window, double-click the Local Area
Connection icon. The Local Area Connection
Status window opens.
3. In the Local Area Connection Status
window, click Properties. The Local Area
Connection Properties window opens.
4. In the Local Area Connection Properties
window, click Internet Protocol (TCP/IP), and
then click Properties. The Internet Protocol
(TCP/IP) Properties window opens.
5. In the Internet Protocol (TCP/IP) Properties
window select both Obtain an IP address
automatically, and Obtain DNS server
address automatically; then, click OK.
14
continued
6. When the Local Network window opens, click
Yes to restart your computer.
Macintosh
Follow these steps to verify that the TCP/IP
communications protocol and an Ethernet device
are installed on your Macintosh computer.
1. Click the Apple icon in the upper left corner
of the Finder. Scroll down to Control Panels,
and then click TCP/IP.
2. Click Edit on the Finder (gray bar) at the top
of the screen. Scroll down to the bottom of the
menu, and then click User Mode.
3. Click Advanced in the User Mode window,
and then click OK.
4. Click the Up/Down selector arrows located
to the right of the Connect Via section of the
TCP/IP window, and then click Using DHCP
Server.
Advertisement
Table of Contents
