Attaching The Cable Management Bracket - Cisco Catalyst 9800-80 Installation Manual

Attaching the Cable Management Bracket

Step 8
Tighten all the screws on each side to secure the chassis to the equipment rack.
The following figure shows the Cisco Catalyst 9800-80 Wireless Controller on a two-post equipment rack.
Figure 10: Cisco Catalyst 9800-80 Wireless Controller Installed on a Two-Post Equipment Rack
1 Rack equipment rail
What to do next
This completes the procedure for installing the chassis on a two-post rack. Proceed to the Attaching a Chassis
Ground Connection section to continue with the installation.
Attaching the Cable Management Bracket
Before you begin
The cable management brackets should be mounted to each rack-mount bracket on the chassis to provide
cable management to both sides of the chassis. These brackets are screw-mounted to the rack-mount brackets
to allow easy installation and removal of cables.
Cisco Catalyst 9800-80 Wireless Controller Hardware Installation Guide
46
2 Rack mount bracket ear and screws
Installing the Controller